Noted:

— Each heat press is different. It is recommended that you test your press at different pressure/temperature/time settings to determine the best settings for you.
— Please increase the temperature to 330-340ºF if there are lots of tiny portions or small letters in your design.
— It is recommended to press again for 2-5 seconds after peeling the film off. It will help the adhesive stick stronger, especially when you have tiny portions in your design.

Heat Transfers Troubleshot?
—CRACKING:
Cracking is 99% of the time caused by not enough pressure. Make sure your press is set to be hard to open and close. It is recommended that you use 60PSI. All screens will eventually crack, it is just the nature of the ink but the proper application will make them last a long time.
–STICKING:
If your transfer is sticking to the transfer paper and not releasing you will need to up your temp a few degrees and add extra pressure. Your paper should easily peel off leaving behind the perfect transfer.
–PEELING:
If your transfer is peeling up from your shirt this means that the transfer wasn’t properly applied to your shirt. You need to up your temp and pressure.

–NOTE:
Each heat press machine is slightly different. It is recommended that you test your press at different pressure/temperature/time settings to determine the best settings for you.